Large Swimming Pool Re-levelled

The water would no longer drain to the shallow end, so the pool reticulation system would not work and the pool water could not be filtered properly.

The pool had been built in sections of precast concrete. Using a carefully sequenced program of expanding resin injections into the foundation ground under the pool the team brought the complex pool structure right back to level without mishap.

We were commissioned to lift the pool back to level. The pool had been built in precast concrete sections. The walls were precast with flat bases and concrete infill precast sections formed the floor of the pool.

The floor joints were set down with mastic filler and vertical joints were mastic filled. The fact that the sections were pre-cast dictated a need for extremely precise and careful lifting. Over-lifting any one section could break the joint. Also, due to its large precast base, the wall could easily rotate inwards or outwards.

Additionally, as the floor slab was sitting on a step joint, the internal slab could not be lifted as this could have caused this slab to lift at the joint. This meant a slow process of lifting each precast wall section a small amount at a time to slowly bring the pool back to an acceptable level.

Then the correction of levels was proved by pouring water in the gutter. The water in the gutter flowed to the shallow end again. Then the voids under the internal pool slab were filled very slowly with great care.

The result was extremely successful and the Regional Council saved a great deal of money compared with the alternatives. The chief council engineer congratulated the team on this excellent and problem-free result.